data sheet no. pd10049 revi series pva13npbf microelectronic power ic hexfet ? power mosfet photovoltaic relay single-pole, normally-open, 0-100v ac/dc, 375ma general description the pva13 series ac relay (pva) is a single- pole, normally open, solid-state replacement for electromechanical relays used for general purpose switching of analog signals. it utilizes international rectifers hexfet power mosfets as the output switches, driven by an integrated circuit photovoltaic generator of novel construction. the output switch is controlled by radiation from a gaalas light emitting diode (led), which is optically isolated from the photovoltaic generator. the pva13 series overcomes the limitations of both conventional electromechanical and reed relays by offering the solid state advantages of long life, fast operating speed, low pick up power, bounce-free operation, low thermal offset voltages and miniature package. these advantages allow product improvement and design innovations in many applications such as process control, multiplexing, automatic test equipment and data acquisition. the pva13 can switch analog signals from thermocouple level to 100 volts peak ac or dc polarity. signal frequencies into the rf range are easily controlled and switching rates up to 450hz are achievable. the extremely small thermally generated offset voltages allow increased measurement accuracies. these relays are packaged in 8-pin, molded dip packages and available with either thru-hole or surface-mount (gull-wing) leads, in plastic shipping tubes. applications ? process control ? data acquisition ? test equipment ? multiplexing and scanning features ? bounce-free operation ? 10 10 off-state resistance ? 1,000 v/sec dv/dt ? 5 ma input sensitivity ? 4,000 v rms i/o isolation ? solid-state reliability ? ul recognized ? esd tolerance: 4000v human body model 500v machine model (hexfet is the registered trademark for international rectifer power mosfet s) part identifcation pva1352npbf pva1354npbf PVA1352NSPBF pva1354nspbf pva1354ns-tpbf thru-hole surface-mount (gull-wing) surface-mount, tape and reel www.irf.com 1
series pva13npbf www.irf.com 2 electrical specifcations (-40c t a +85 c unless otherwise specifed ) input characteristics pva1352n pva1354n units minimum control current (see fgures 1 and 2) dc for 325ma continuous load current 2 ma@25c for 370ma continuous load current 5 ma@40c for 190ma continuous load current 5 ma@85c maximum control current for off-state resistance at 25c 10 a(dc) control current range (caution: current limit input led. see fgure 6) 2.0 to 25 ma(dc) maximum reverse voltage 6.0 v(dc) international rectifer does not recommend the use of this product in aerospace, avionics, military or life support applications. users of this international rectifer product in such applications assume all risks of such use and indemnify international rectifer against all damages resulting from such use. general characteristics (pva1352n and pva1354n) units dielectric strength: input-output 4000 v rms insulation resistance: input-output @ 90v dc 10 12 @ 25c - 50% rh ? maximum capacitance: input-output 1.0 pf max. pin soldering temperature (1.6mm below seating plane, 10 seconds max.) +260 ambient temperature range: operating -40 to +85 c storage -40 to +100 output characteristics pva1352n pva1354n units operating voltage range 0 to 100 v (peak) maxiumum load current 40c, i led 5ma 375 ma (dc) response time @25c (see fgures 7 and 8) maximum t(on) @ 12ma control, 50 ma load, 50 vdc 150 s maximum t(off) @ 12ma control, 50 ma load, 50 vdc 125 s maximum on-state resistance 25c (pulsed) (fgure 4) 50 ma load, 5ma control 5 ? minimum off-state resistance 25c @ 80 vdc (see fgure 5) 10 8 10 10 ? maximum thermal offset voltage @ 5.0ma control 0.2 volts minimum off-state dv/dt 1000 v/s typical output capacitance (see fgure 9) 11pf @ 50vdc
series pva13npbf www.irf.com 3 85 oc i le d = 5 ma , f or ce d a ir 25 oc 40 oc 60 oc pu ls ed , 2 5o c figure 1. current derating curves figure 2. typical control current requirements figure 3.typical on characteristics figure 4. typical normalized on-resistance rd(on) (ormalized to 25c) i led (ma) ambient temperature (c) max. load current (ma) vdd (volts) load current (ma) ambient temperature (c) max. load current (ma) 0.0 0.5 1.0 1.5 2.0 2.5 3.0 0 20 40 60 80 100 500 450 400 350 300 250 200 150 100 50 0 800 700 600 500 400 300 200 100 0 i led =10ma i led =5ma i led =2ma
series pva13npbf www.irf.com 4 idoff/idoff 25c figure 5. normalized off-state leakage figure 6. input characteristics (current controlled) figure 7.typical delay times figure 8. delay time defnitions led forward voltage drop (volts dc) input current (ma) ambient temperature (c) delay time ( s) i led (ma) 10 10 0 1000 0 5 10 15 20 to n td l y to ff
series pva13npbf www.irf.com 5 figure 9. typical output capacitance typical capacitance (pf) vdd drain to drain voltage 0 10 20 30 40 50 60 70 80 90 10 0 0 1 0 2 0 3 0 4 0 5 0 wiring diagram case outlines 01-2013 00 (ms-001ab)
series pva13npbf www.irf.com 6 ir world headquarters: 233 kansas st., el segundo, california 90245 tel: (310) 252-7105 data and specifcations subject to change without notice. 2/2008 01-2019 00
|
